Every testing scenario covered with accredited methodology.
💨
Non-Viable Spore Trap Air Sampling
The workhorse of mold air testing. Spore traps collect non-viable particles — both live and dead spores — giving total spore counts by genus. Standard for most Aurora residential and commercial testing scenarios.
🏭
Viable Culture Air Sampling
When genus-level ID isn't enough, viable culture plates give you species confirmation. Critical for Stachybotrys chartarum investigation and occupational health documentation in Aurora, MN.
🎖
Surface Swab & Tape Lift Sampling
Surface samples collected from visible growth areas — swabs for culture analysis or tape lifts for direct microscopy — identify the species present on specific surfaces. Used to confirm whether visible staining is mold and which genus/species is involved before committing to remediation scope.
📄
Post-Remediation Clearance Testing
After mold remediation, clearance testing compares treated zone air samples to outdoor baseline — confirming indoor spore counts are back to acceptable levels before re-occupancy. Our Aurora, MN clearance testing uses the same accredited lab protocol as pre-remediation sampling, so results are directly comparable.
🏢
HVAC & Ductwork Air Testing
Register-versus-room comparative sampling identifies whether your Aurora, MN HVAC system is amplifying or distributing mold — essential before deciding whether duct cleaning will actually help.
🔋
Bulk & ERMI Sampling
Bulk material samples and ERMI (Environmental Relative Moldiness Index) floor dust sampling give a cumulative picture of historical mold presence in a Aurora, MN property. ERMI uses qPCR analysis on settled dust to identify 36 mold species — often used in post-remediation verification or occupant health investigations.
